Enmet EX-6100 Series Manuel d'utilisateur télécharger pdf (Page 14)

EX-6100

ENMET Corporation

Step 4

Remove the sensor board from the rear of the sensor – do not disconnect the wires from the main board.

Step 5

Remove sensor insert using maintenance tool or slip joint pliers.

Step 6

Mark the sensor pin position & undo the snap ring that retains the sensor in its housing.

Step 7

Replace the sensor taking note of the pin marking in step 6.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Pas de commentaire

Enmet EX-6100 Series Manuel d'utilisateur Page 14