Enmet EN Series Manuel d'utilisateur

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 Manual Part Number 80003-133 MCN-339, 10/04/05 EN / SDS Elec

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 8 Appendix A: Interference Table For Selected Sensors Ammonia (3E-100 sensor) The

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 9 Chlorine (3E sensor) The following gases cause a reading: Interferant Gas/Vapor I

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 10 Hydrogen Cyanide(2E 30 sensor) The following gases cause a reading: Interferant

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 11 Hydrogen Chloride(3E sensor) The following gases cause a reading: Interferant G

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 12 Fluorine (3E 10 sensor) The following gases cause a reading: Interferant Gas/Vap

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 13 Nitric Oxide (3E 100 sensor) The following gases or vapors have been tested and d

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 14 Ozone (3E 1 sensor) The following gases cause a reading: Interferant Gas/Vapor I

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 15 Phosgene (3E sensor) The following gases cause a reading: Interferant Gas/Vapor

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instrumen

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.

Table of Contents INTRODUCTION ...

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 1 Introduction The ENMET toxic and oxygen sensor/transmitters (S/T) model EN serie

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 2 2.0 Mounting and Wiring Each sensor/transmitter circuit and sensor are in a NEMA-4

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 3 2.1 Installation of Sensor/Transmitter 1. J Remove the cover, and mount the S/T in

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 4 3.0 Initial Calibration The S/T is pre-calibrated at the factory before shipment,

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 5 4.0 Standard Ranges, Calibration Gases, Voltage Readings at Calibration Points and

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 6 5.0 ENMET Part Numbers 5.1 Replacement Sensors Sensor Gas Type ENMET Part Number

Sensor/Transmitter, Toxic Gas & Oxygen ENMET Corporation 7 6.0 Warranty ENMET warrants new instruments to be free from defects in workmanshi