Enmet EX-5000 Manuel d'utilisateur

ENMETENMET CorporationPO Box 979Ann Arbor, MI 48106-097980003-029MCN-182, 02/11/98MCN-204, 02/29/00MCN-230, 02/29/00MCN-234, 04/25/00MCN-240, 10/30/00

ENMET Corporation MOS S/T83.2 Initial CalibrationThe S/T has been precalibrated at the factory before shipment, and initial field calibration should r

Catalytic & MOS S/T ENMET Corporation94.0 WARRANTY4.0 WARRANTYENMET warrants new instruments to be free from defects in workmanship and material u

ENMET Corporation Catalytic &MOS S/T10Addendum: Ammonia CalibrationAddendum: Ammonia CalibrationCalibration Procedure for EX-5000 MOS AmmoniaThe E

Table of Contents1.0 INTRODUCTION...

Catalytic & MOS S/T ENMET Corporation11.0 Introduction1.0 IntroductionThe ENMET catalytic and MOS sensor/transmitters (S/T) are, three or four wir

ENMET Corporation Catalytic S/T21.2 Features of Sensor / Transmitter1.2.1 Magnetic Switches and PotentiometersMagnetic switches control the span and p

Catalytic S/T ENMET Corporation32.0 Catalytic Combustible Gas Sensor/Transmitter Installation2.0 Catalytic Combustible Gas Sensor/Transmitter Installa

ENMET Corporation Catalytic S/T42.1.2 WiringRun conduit and 16 AWG wires to the enclosure from the power supply and controller. Since combustible gas

Catalytic S/T ENMET Corporation5Figure 3: Catalytic Combustible Gas Sensor/Transmitter1. Apply the calibration gas associated with the S/T to the sen

ENMET Corporation MOS S/T63.0 MOS 3.0 MOS Combustible and Toxic Vapor Sensor/Transmitter InstallationCombustible and Toxic Vapor Sensor/Transmitter In

MOS S/T ENMET Corporation73.1.2 WiringRun conduit and 16 AWG wires to the enclosure from the power supply and controller. Since combustible gas may b