Enmet SMARTLOGGER Manuel d'utilisateur télécharger pdf (Page 13)

SMART LOGGER ENMET Corporation

3.6 Connection to a Printer

The SMART LOGGER keeps the following data in memory:

- Events, such as alarms, resets, faults, etc.

- Measurements for a duration of 120 working hours. This duration may be reduced by a proliferation of memorized events.

So you can output statistical charts on a printer, connection is made with the CHARGE/PRINT mini-DIN plug located on top

of the instrument by means of the printer cable.

The printer must be of the serial type compatible with an IBM-PC.

- Plug in the connecting cable between the SMART LOGGER and the printer

- Turn the printer on, configure it, position "on line." See Section VI.

- Turn the SMART LOGGER on with the ON/OFF switch

- Press the OPTION switch, which starts the printing process

The display indicates:

If the instrument working duration has been less than 15 minutes, only the events are printed in chart form. For a duration of

16 minutes or more, the events are followed by a histogram representing the measurements, as shown below.

HISTOGRAM : From 09/18/93 at 12:17AM

% OXYGEN

24.0_

18.0_

12.0_

00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16

Time (h)

PRINTING

Type :TX12 Version GB 1.1 No. :94-04-00843

Type of gas : Oxygen

Range : 0-30.3 % O2 High Alarm : 23.5 % O2

Low Alarm : 19.5 % O2

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Enmet SMARTLOGGER Manuel d'utilisateur Page 13