Enmet ENG – 97D STAND-ALONE Manuel d'utilisateur télécharger pdf (Page 6)

ENG-97D S

TAND

-A

LONE

ENMET Corporation

3.0 Installation

3.1 Mounting Control

Open the cover and mount the instrument where desired as a C

ONTROL

for the associated sensor/transmitter, using appropriate

mounting screws and the rubber seal washers supplied. See Precautions in introduction, regarding selection of the location.

See Figures 2 and 2A for mounting dimensions.

3.1.1 ENG-97D S

TAND

-A

LONE

in standard enclosure

Figure 2: Installation Diagram, Rear View

OTE

Allow at least 3 inches at the bottom of the closed enclosure for cable fittings and cable.

3.1.2 ENG-97D S

TAND

-A

LONE

in NEMA-4X enclosure

Figure 2A: Installation Diagram, Internal View

OTE

Allow at least 3 inches at the bottom and to the left of the closed enclosure for cable fittings and cable.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Enmet ENG – 97D STAND-ALONE Manuel d'utilisateur Page 6